Use the same needle nose pliers to just turn the hex nut some to the left so you can unscrew it with your fingers. Removing the hex nut Then you will see a hex nut (six sided nut). Just twist the hand and pull it toward you until it comes off.ģ. Next is the hour hand, this is only a friction fit with a round hole in the hand, the tube its on tapers fatter as it goes down into the movement. To take this off, hold the minute hand still as you turn the nut to the left with needle nose pliers to loosen the nut so you can take it off with your fingers. The other style (the kind we sell) has the nut on the top of the minute hand to hold it down. The friction fit with no nut style just pulls straight off like the second hand did. There are two styles to the minute hand, the kind that has the nut holding it down and the kind that is only on by friction fit with a round hole in the hand. Removing the hands If there is a second hand on the clock, just grab it with your thumb nails and pull it straight off of the clock to take it off. Once you're at the point where you can remove the hands and also the back of the quartz unit, you're good to start replacing the unit. You may have to remove some screws, or if there is a bezel it maybe required to bend the bezel tabs some to get it off. This is so you can take it apart enough to get to the dial. Sometimes it is very easy to get to the dial and hands, but other times glass covers the dial and you have to figure out how the clock case was put together. Getting to the dial There are many case designs and styles and there is no telling what way you're clock case is made to get to the dial (face) of the clock. Alkaline batteries are best used in “low-drain” devices, which includes clock movements.Removing a Bad Unit The first step to replacing a quartz movement, is to be able to get to the movement from the back and also the front where the hands are. Lithium and rechargeable batteries are meant for “high-drain” devices, such as digital cameras, etc. Lithium powered or re-chargeable batteries will cause your clock to malfunction, or not function at all. Alkaline batteries are the only type of battery that should be used in clocks. Other brands, such as Energizer, have extra plastic coating on the negative end of the battery, which can cause clocks to malfunction or not work properly at all. We recommend using Rayovac or Duracell brand. **When choosing the proper batteries for your clock, please consider the following information: There are many brands of alkaline batteries available on the market today, but there are several brands out there that just don’t perform well in clocks.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |